sdr mini
all band qrp cw transceiver

external tuning knob
and buttons

video

Description

Low cost DXing from a small garden
with a cheap but excellent sdr cw transceiver

I have had many kinds transceiver (Kenwood TS 870, TS-950SD TEN-TEC...) the last 30 years
but honestly I have never used such a good radio before.
The soul of this transceiver an amazing perfomance Airspy HF+ sdr receiver from USA.
I just 'dropped' some parts around this little module and reached 132 DXCC on 40m band in 4 months.
I used a simple GP antenna this winter season. It worked very well both RX and TX sides.

Of course this setup works any kind of sdr receiver and software which supports Kenwood CAT protocol.



 I usually turned on the 200 watts PA  but I have had a lot of QRP QSO also (e.g. RI1ANE Antarctica 8 Watts).

Shack

Antenna

Hardware

ESP32 wroom module serves all function. Serial communication protocol between radio and sdr software. Elkey with memories and SINEWAVE sidetone. It controls relays, buttons, TFT and SI5351 module.
I used a qrp power amplifier from my old 6 bands radio. With 15V power supply it has 8W output on 40m band. I can match it every bands with help of my favorite Drake MN7 tuner.

Schematic

Schematic PDF
DOWNLOAD

Software

I changed my development environment from arduino IDE to VSC & platformIO. Shortly I like it:)
DOWNLOAD SOURCE CODE

SDR software

I tried out some sdr software and finally chose SDR CONSOLE
Setup is really simple only 2 steps.
View - More options - Select - to check External Radio option

Tools -Options - Port selection - select your esp32's serial port
Set baud rate to 57600 if necessary.

If there is only one receiver the TX RX frequency are same. If you add second receiver then it will be always the TX frequency.
I use an external Steinberg UR22 high quality sound module.